Use this overlaminate to provide an extra layer of protection and/or enhance the gloss of an electrostatically imaged graphic – both indoors and out. It also can be used to laminate selected Piezo Ink Jet graphics.

When used with compatible products, produced by one of 3M’s Scotchprint® Graphics Authorized Manufacturers and applied according to written instructions, this film can be used to produce a Scotchprint® Graphic.

• Overlaminate 8910 (ES) produces a luster finish and can be used with most squeeze roll laminators; no heat is required.
• This overlaminate also offers excellent protection against abrasion and harmful UV rays.

Overlaminate 8910 (ES):

• is a 2 mil (0.05 mm) transparent, vinyl film; 2 to 4 mil (0.05 to 0.10 mm) with the adhesive
• has a clear, pressure-sensitive adhesive
• has a 78# paper liner

This film can be used on flat, riveted and corrugated surfaces. It should be applied at room temperature.

Overlaminate 8910 can be used to laminate:

• Selected 3M^TM Controltac^TM Plus Electrostatic Graphic Films
• Selected 3M^TM Scotchcal^TM Electrostatic Graphic Films

• Selected 3M^TM Electrostatic Display Papers
• Selected 3M^TM Scotchlite^TM Reflective Sheetings
• Selected 3M^TM Piezo Ink Jet Graphic Films
• 3M^TM Banner Material 8450

This product is covered by the 3M^TM MCS^TM Warranty – the most comprehensive warranty in the industry.

Overlaminate 8910 (ES) is available in 36", 49.5" and 54" wide by 50-yard long rolls and 54" wide x 100-yard long rolls.

Unprocessed film has a shelf life of two years; processed film has a shelf life of one year. It should be stored in a clean, dry area, out of direct sunlight, and at a temperature less than 86ºF (30ºC).

For more specific product information, please refer to Product Bulletin 8910.